Playstation
when you load jailbreak playstation and need to send from host .elf use this command from linux:
That's because Debian 13's nc implementation doesn't support -q.
Use the command without -q0:
nc lan-ip-address-eh 9021 < kstuff.elf
Or explicitly use the OpenBSD netcat syntax available on Debian:
nc -N lan-ip-address-eh 9021 < kstuff.elf
-N tells nc to shut down the socket after stdin reaches EOF, which is the closest equivalent here to -q0.
You can first check which implementation you have:
nc -h 2>&1 | head -30
And verify the port:
nc -vz lan-ip-address-eh 9021
So I'd use:
nc -N lan-ip-address-eh 9021 < kstuff.elf
If it immediately returns without an error, check the PS5-side loader/log for whether it received the ELF.
how to install Drakmor’s apr emu in our dump game
If you mean Drakmor’s APR-EMU for PS5, the basic setup for a game dump you legally made yourself is:
Make sure the dump is an APR-compatible clean game dump. APR-EMU is still under development, and compatibility varies by game.
Get the current libSceAmpr.sprx from Drakmor’s APR-EMU release/testing channel. Versions have been changing frequently, so avoid assuming an old 0.2.x build is current.
In the game's root directory, create:
fakelib/
Put the APR library inside that folder, normally as:
fakelib/libSceAmpr.sprx
Community documentation describes APR-EMU, PlayGo emulation, and DLC emulation as libraries installed in the game's fakelib directory.
Depending on the game, you may also need PlayGo emulation (pgo_stub), DLC emulation, and KStuff/ShadowMountPlus. These aren't universally required for every title.
Don't run an APR-EMU game from the internal PS5 drive unless the current release explicitly supports it. Earlier public-beta guidance warned that doing so could freeze the console or trigger Recovery Mode; later releases have improved support, so check the release notes for your exact version.